Stamps and Ink Pads

Materials Needed:
Stamps and Inkpad Printies (See Step #1)
Tacky Glue
Scissors
Exacto
Scrap pieces of 1/16"balsa wood
Pencil erasers
One sheet of White Fun Foam or Foamtastic
Approximate time to complete this project: 15 minutes
Step#1 - (You can skip this step if you've printed out all the Printables from the main page.) Right click on the image below and "Save as" to your desired location. You may need to adjust the image using a graphics program. You can obtain the correct scale by making sure that the one ink pad printie is a 1/4 inch long. To preserve the quality of the ink, I suggest spraying them with a clear gloss sealer.
Step#2 - Print the Stamps and Ink Pad printies out on cardstock and cut out. Set Stamps printies aside. Cut small rectangles of fun foam slightly larger than the printies. Glue Ink Pad Printies to fun foam. When dry trim off excess fun foam.
Step#3 - Using your Exacto cut pieces of balsa wood the same size as the Stamps printies. You may want to sand the edges a bit. Glue the Stamp Printies onto the balsa wood and let dry.
Step#3 - Meanwhile, using your exacto cut some slices from a pencil eraser. Cut the circles into squares or rectangles to fit on the bottom of the stamps. Place a dot of Tacky glue on the bottom of the stamp and add the eraser.
Step#4 - You're done!